1
Config file path is ./. file is vchatserver.conf
2
This appears to be a new server. Some information is needed in order to configure the servers.
3
Answer the following questions:
4
Enter the UDP port that will be used for this server.
5
Leaving this blank will default the port to 7878:

1
Enter an admin password (max length is 32)
2
: yourPassword1

1
Enter a password for the server, or leave blank for no password (max length is 32)
2
: yourPaaword2

1
Enter a name for the server
2
: yourServerName

1
Enter a limit to the number of clients that can be in the server at the same time,
2
or leave this blank or enter 0 to have no limit
3
: yourLimit

1
Enter the desired voice codec band (value between 1 and 3)
2
  (1) Narrow Band - 8KHz (worst quality)
3
  (2) Wide Band - 16KHz (good quality)
4
  (3) Ultra-wide Band - 32KHz (best quality)
5
: yourChoice

1
Enter the desired voice codec quality. This is a value between 0 and 10,
2
0 being the worst quality, 10 being the best quality.
3
Note that the better the quality the more bandwidth it will use.
4
: yourChoice

1
Should the remote admin interface be enabled?
2
Enabling this will bind a TCP socket to the same port as the port entered above
3
that will allow the use of Voicechatter's remote admin interface.
4
If you do not know what this means, it is perfectly safe to answer 'no'
5
(y/n): yourChoice

1
Should IPv6 functionality be enabled?
2
Turning this on may make the server unreachable if your os is not configured for proper IPv6 support.
3
If you don't know what any of this means, or if you are not sure that your OS or network will support IPv6,
4
answer 'no' to this question.
5
(y/n): yourChoice

1
Configuration is now complete, starting server...
2
YYYY/MM/DD HH:MM:SS: Starting server version 1.5.0...
3
Starting server
4
Checking for inactive clients
5
READ: 0 bytes/10 sec(0.00 kB/s，0.00 kb/s)
6
SEND: 0 bytes/10 sec(0.00 KB/s，0.00 kb/s)